C9850-063A Single-layer water-base nano-ceramic coating
Evironment-friendly alcohol-base or water-base ceramic coating High hardness (Higher than 6H), superior hot hardness
| Physico-chemical Parameters | ||||
| Product model | C9850-063A/B/C | Test method | ||
| Solid content, % | 52.5±2.0% | 250°C×30min | ||
| Density, g/ml | 1.18±.0.1g/ml | Specific gravity cup | ||
| Viscosity, (25°C) CP | 9S ~ 15S | Ford cup, #4 cup | ||
| Appearance | White | Eyeballing | ||
| Gloss | 45 - 65 | 60° gloss meter | ||
| Substrate | Die casting aluminum | / | ||
| Sintering temperature | 300°C×10min | / | ||
| Film thickness, μ | 38±7 | Coating-thickness gauge | ||
| Hardness | 6H | ZHONGHUA pencil /normal temperature | ||
| Adhesion | First class | Cross hatch test, 100/100/3M adhesive tape | ||
| Spraying of coating | ||||
| i) Spraying method | ||||
| Compressed air spraying is available. All general spray guns (pressure feed type,gravity feed type and siphon type) could be used. The caliber of spray nozzle is Ø0.8mm-1.5mm, the spray head pressure is 1.50kgf/cm² ~ 4.0kgf/cm². The spray gun shouldkeep a certain distance from workpiece in accordance with the spraying environmentand coating properties. | ||||
| ii) Spraying process | ||||
| a) The spraying environment should be dry, well-ventilated and has no dust. Reducethe impact on spraying quality caused by spraying environmental factors.b) We recommend preheating the substrate at 40°C-80°C before spraying, payattention to the uniformity and thickness of film during spraying and keep the dryfilm thickness in the range of 38μm±17μm. | ||||
| iii) Film curing | ||||
| Dry the sprayed workpiece from 50°C, and increase the temperature slowly, (sinteringcondition: 250°C * 30min or 300°C * l0min) . Both over high beginning temperature and rapid temperature increasing could leadto blister.Adjust the holding time according to the size of substrate and heat conductivity ofthe material during curing process. | ||||
| iv) Cool down the workpiece | ||||
| Both natural cooling and air cooling are available. | ||||
| torage of coating | ||||
| i. The storage place should be shady, dry, well-ventilated, and should keep away from the source of ignition and heat. It can be stored for 3 months at the temperature of 5°C ~ 25°C. Be stored at a temperature above 30°C or below 0°C is forbidden. If it is left unused for long time, shake twice a day at a speed of 120rpm ~ 200rpm to preventthe coating from settling, deteriorating, and seeding.ii. After mixing, the coating can be stored at 5°C ~ 15°C for 36 hours, 15°C ~ 30°C for 24 hours, and at about 5°C for 72hours ( we suggest the unused coating being storedat about 5°C ). Be stored at a temperature above 30°C or below 0°C is forbidden. |
Experience Makes Difference!
Pls contact me if you have any problems,we can manufactuer according to your requirement!
May Xiong
Tel: 86 010-64021466 010-64021477 ext 232
Fax: 86 010-64078878
Mob: 86 13691262619
Email: mayxiong@ aiet.com.cn
C9850-063A Single-layer water-base nano-ceramic coating
