Solar Working Station for Solar Water Heater, with controller, wilo pump, two pipes, flowmeter, thermometere...
Solar Working Station / Solar Work Station for Solar Water Heater/Solar Water Heating System / Solar Controller
1.Inlet2.Manipulate screen3.Pump speed adjust switches4.Temperature difference circulation pump5.Expansion connector6.Display screen of flux and temperature7.Manometer8.Relieve air valve9.Safety valve10.Wall mounting11.Flow trip connector12.Return trip connector
Components of pipeline1.Safety valve: protects the system components against excessive over-pressure in all operating phases.2.Ball valve,check valve:brass material3.WILO pump:this pump is a standard device in the system,it required operating point can be preselectedusing one of the three levels.4.Manometer:adopt hydraulic aseismatic manometer with a range from 0 to 10 bar indicates the systempressure.5.Connect of expansion vessel: install expansion vessel,avoid the system working at minus pressure.6.Flow sensor:timely monitor medium flow of the whole system..7.Exhaust setting:adopt spray-paint steel tube, it can release air cause of medium flow in the pipeline.According air quantity and frequency which cause of system, we can examine whether this system haveleakage phenomenon.8.Pipeline temperature display: medium temperature between right trip and return trip, can be displayed atfirst time. Temperature sensors are packed in a tube, Do not need to turn off any parts when replace it.9.Medium inlet:turning the handle 90° to left so that medium can be injected in it..10. Heat preservation material:EPS11. Screw thread:1/2inch.12. Maximum working temperature of pipeline:flow trip(manometer side)150oC
return trip(pump side)110oC
SP226 Technical data1.externality size: 450mm*310mm*150mm2.Max. self consumption: ≤3W3.Accuracy of temperature measuring: ±2oC4.Range of temperature measuring: 0~150oC5.power of controlled pump (temperature difference circulation pump, water-using end circulation pump):<600W6.electronical booster power: ≤3000W7.input signal: 3 temperature sensors (for top of tank, for heat collector, for bottom of tank)8.output signal: 3 (electronic booster, temperature difference circulation pump and water-using endcirculation pump)9.System working pressure: 8 bar and safety valve response pressure 6 bar.
InstallationVertically installation,installed at flow and return trip of collector and water tank. As above picture.AdvantageA.Designed for self-sustaining solar operationB.Easy installation, save cost, beautiful appearanceC.Easy to check the flux of pipeline, temperature display.D.Constant air separation during line operation,check system whether have leakage.
Solar Working Station
